The micro water meter is suitable for humidity measurement of SF6 gas, and is applicable to a wide range of fields, such as humidity measurement of air, nitrogen, inert gas and any gas without corrosive medium, especially suitable for humidity measurement of SF6 gas, electricity, petrochemical, Metallurgy, environmental protection, scientific research institutes and other departments can use it, and it has a very high cost performance.
Before using the micro water meter, the operator must make sufficient preparations. Only when the preparation work is done, when using the micro water meter to measure objects, can the measurement work be carried out smoothly and avoid many unnecessary troubles. .
Preparation before using the micro water meter:
1. Place the micro water meter in a stable area. If the analyzer is not placed properly when it is placed, the accuracy of the later measurement data cannot be guaranteed;
2. Prepare all the items to be measured in advance, don't wait until the time to measure, then start looking for the items that need to be measured, this will only delay the measurement time;
3. Do not do anything during the startup process of the micro-water analyzer. After the analyzer is fully working, perform the next operation on the instrument;
4. In order to prevent the deviation of the data measured by the analyzer, after turning on the analyzer, you must pay attention to debugging the relevant data. In the process of debugging the micro water meter, adjust the measurement range according to the items to be measured.