Correct use of equipment

After ensuring that the external power supply is normal, the first step is to power the device. The main circuit breaker of the electrical box, the white power indicator light of the operation box should be lit. Step 2: The device starts . Turn the power switch on the operation box panel (left for on, right for off ) . The touch screen on the board should light up and rotate to release the Emergency Stop " switch. Step 3: Figure Paper Settings . Click "Paper Settings" Enter the drawing setting page and enter the number of turns for each section ( Note: The latter part should be larger than the former part ) and enter the drawing number in the upper right corner of the screen (the drawing number should be is less than 32767 A positive integer

within this range, the user can determine a number by himself ), then Then click "Call" in the upper left corner " button to call this set of drawings . "Will flash The flashing display indicates that this set of drawings has been called, and the number of turns of the drawings will be displayed in the coil display. The number will be displayed on the "Main Page "The current drawing number. Step 4: Winding settings. Click "Winding System Settings "Enter the winding setting interface and set the wire diameter and wire width. ( Note that the delay time is The distance cannot be adjusted privately). Step 5: Start winding. After the beginning is done, first The accumulated turns and current segments are cleared. If you start from the left (right),

please dial Automatically wind to the right (left), and start winding after pressing the foot switch . Step 6: Winding is completed. After the wrapping is completed, the wire package is removed, the emergency stop button is pressed, and the automatic and manual left and right shift keys are all returned to the center. Turn the rotary switch to the left (left to open and right to close ), and pull down the main switch on the side of the electrical box to cut off the power to the equipment.