The cable fault tester is suitable for measuring low-resistance faults and short circuits of power cables, high-frequency coaxial cables, local telephone cables, street light cables, and two or more parallel buried wires of various materials with different cross-sections and different media. Faults, open circuit and disconnection faults, as well as high resistance leakage faults and high resistance flashover faults.
Street lamp cable fault tester is dedicated to street lamp cable fault detection. In fact, cable fault tester manufacturers are named after the cable fault tester equipment model, similar to this field of street lamp cable fault tester and communication cable fault tester. In fact, the test principle is the same. Let me introduce three detection methods of the street lamp cable fault tester.
1. Detect with megohmmeter
This method is the traditional street lamp cable fault detection method. The power supply radius of the street light line is generally between 0.4-0.6km, and the distance between the street lights is 30-40m. The entire line looks like a tree trunk and the load is relatively scattered. To detect the insulation resistance of the cable between phases and ground, the street lamp load must be cut off first, then the intermediate point is selected to disconnect, the phase-to-phase and ground insulation tests are performed with a megger, and the troubleshooting method is used to determine the direction of the fault point. This method is basically not used now.
2. Test with clamp ammeter
The principle of using a clamp-on ammeter to detect street light cables is: by restoring the burnt-out fuse, the street light cable is instantly (2-3 seconds) powered (Note: the short-term instantaneous current will not cause the street light cable to quickly heat up, ie Will not cause new damage to the street light wires and cables), according to the law that the fault current from the fault point to the power supply is very large, and the current from the fault point is small, when the detected current value becomes the normal value, the current value is normal The previous range of the lamp position of the value is the fault point.
3. Detect with special fault tester for street lamp cable
At present, there is an instrument that integrates street lamp wire and cable path detection, buried depth measurement and fault point location. This detector is small in size, placed in a portable toolbox, light in weight, and can be easily operated by a single person; it is powered by a battery and does not require a 220V power supply, which is suitable for field operations; the cable path search, buried depth, and fault location location can be completed simultaneously, and it is efficient High, not subject to external interference; not affected by cable underground conditions (bifurcation, joint twisting, winding), like mine exploration, point to point to find fault points, the error is in centimeters; not affected by ground conditions, such as floor tiles, greening Belt, cement surface, etc. The detector is composed of a transmitter and a receiver. The transmitter can use single-frequency transmission or radio frequency transmission according to the site conditions (audio is suitable for long distances, and radio frequency is suitable for short-distance and interference situations); The rod induction signal determines the path and the fault point of the street light cable, easy operation, and accurately locates the street light cable fault point
