+86-312-6775656

How to clean and maintain the filter element of the vacuum oil filter

Apr 13, 2021

First of all, there is no doubt that the normal cleaning and maintenance of an oil filter can prolong its service life. Therefore, we should correctly select the filter element of the vacuum oil filter, because the model between the filter element and the equipment is matched, if the selection is not appropriate, the filtering effect will be affected.


Vacuum oil filter cleaning precautions:


First of all, the filter element of the vacuum oil filter needs to be cleaned and replaced in time, because the impurities in the oil will accumulate on the filter element during the oil purification process. If it is not clear for a long time, the oil filtering speed will slow down and the oil quality will not be clean enough.


Second, the axial pressure cannot be increased during use. If so, the oil can quickly pass through the filter, but the filter element is often crushed, which affects the cleanliness of the hydraulic oil.


In order to ensure the cleanliness of the filter element of the vacuum oil filter, the filter element of the vacuum oil filter must be cleaned in time. The method is now described as follows:


1. Before cleaning the vacuum oil filter, the operation of the oil filter must be stopped, the oil inlet and outlet pipes must be closed, and the power switch must be turned off.


2. Open the drain valve and drain all the oil in the filter until the oil flows out (open the drain valve to accelerate the drain).


3. After removing the filter element, open the filter cover and take out the filter element.


4. Vacuum the filter element of the oil filter, take it out and put it in an oil pan filled with kerosene, soak for 30 minutes, then clean it, and blow it off with air.


5. Use a brush to remove the deposits on the surface of the vacuum oil filter, and then wipe the oil filter clean with a rag.


6. Then install the filter element and tighten the filter bolts. It can be put into use after cleaning.


I need to remind everyone that the frequency of use of the vacuum oil filter is not very high. Companies usually concentrate oil for half a year or a year for filtration, or directly connect equipment for filtration. Either way, after using the vacuum oil filter, the inside of the machine must be cleaned with filtered oil once, and then the cleaned oil is drained. Companies with fans can use fans to dry the interior, because some manufacturers' vacuum oil filters will rust if they are not handled well. The dried vacuum oil filter will be covered by a tarp or clinker film and placed in a clean and dust-free place for next use.


Send Inquiry