HZ-B Power Cable Fault Pin Pointer

Magnification

50,0000 times

Working voltage

±9V±20%

Static current

＜10mA

Power dissipation

Quiescent current is less than 10mA, The working current is not more than 10mA

Output impedance

350Ω

Positioning accuracy

±0.2m

1

Place the HZ-B ground-penetrating microphone in the starting position.

2

If HZ-B cannot pick up any sound signal at this measuring point. Please follow the path of the cable under test. When you find that HZ-B receives the first useful impact discharge sound signal, the left side of the LCD of HZ-B host will automatically display the sound level of the measurement point.
If you are unable to pick up the shock discharge sound signal through a ground-penetrating microphone or headphones in a long area, you should try to make a precise point from the starting point in the opposite direction.

3

Please continue to follow the path of the cable under test and move one step at a time. If necessary, adjust the position of the central axis of the cable under test at any time. At each measurement point, please stay a few impulse discharge pulse signals.
When you are near the cable fault point, you will hear a stronger knocking sound, and the sound level of the current measurement point displayed by HZ-B will suddenly increase.

4

Please rotate the HZ-B ground-penetrating microphone 180 ° and use a smaller step to approach the fault point again.

5

Please continue to reduce the step distance, look for the place where the fault is the loudest, and determine the location of the fault point as accurately as possible. Then make an accurate mark on the ground.