6000L/H Mobile High Vacuum Transformer Oil Filtration Machine
Huazheng Electric Manufacturing (Baoding) Co., Ltd. is one of the leading manufacturers and suppliers of 6000l/h mobile high vacuum transformer oil filtration machine in China. Please feel free to buy high quality equipment for sale here from our factory. Good service and reasonable price are available.
6000L/H Mobile High Vacuum Transformer Oil Filtration Machine
|
NO. |
Name |
Vacuum oil purifier |
||||||
|
1 |
Type |
HZLY-60D |
Serial Number |
HFV15049 |
||||
|
2 |
Test Item |
Test Data |
Reference Data |
Unit |
Test Results |
Inspected by |
||
|
3 |
Ultimate vacuum |
5 |
≤133 |
Pa |
pass |
|||
|
4 |
Filter pressure |
0.02 |
≤0.3 |
MPa |
pass |
|||
|
5 |
Flow rate |
6000 |
≥5830 |
L/H |
pass |
|||
|
6 |
Moisture content |
6 |
10 |
PPM |
pass |
|||
|
7 |
Particle size |
1 |
3 |
μm |
pass |
|||
|
8 |
Over voltage protection |
- |
- |
V |
pass |
|||
|
9 |
Under voltage protection |
- |
- |
V |
pass |
|||
|
10 |
Alarm pressure |
0.3 |
0.3 |
MPa |
pass |
|||
|
11 |
Motor current of vacuum pump |
Ia=3.7 |
Ib=3.9 |
Ic=3.9 |
pass |
pass |
||
|
12 |
Motor current of oil pump |
Ia=4.1 |
Ib=4.2 |
Ic=4.3 |
pass |
pass |
||
|
13 |
Current of heater1 |
Ia=45 |
Ib=45 |
Ic=43 |
pass |
pass |
||
|
14 |
Current of heater2 |
Ia=44 |
Ib=45 |
Ic=46 |
pass |
pass |
||
I Installation
1．Connect hoses between the inlet MV02 of the purifier to the outlet (usually at bottom) of the tank, the outlet MV01 of the purifier to the inlet (usually at top) of the tank.
2．Open the drain valve MV13 of condenser ,close the drain valve until the liquid in the condenser is drained.
3．Connect the three-phase three-wire 380V / 50HZ power supply and ground cable to the terminal block, Open circuit breaker QS1, QS2 and QS3. The power indicator on the control panel should be light on.
4．If the power indicator is off, troubleshooting is required according to the PR indicator in the cabinet. The purifier will stop automatically when phase sequence, overvoltage and undervoltage power failure occurs.
5．urn on the “outlet pump” select switch and Turn off the “outlet pump” select switch immediately. Observe whether the direction is in the same as the arrow on the pump body.
6．If the motor is turned incorrect, disconnect the power supply and exchange the wiring of any two terminals of the pump motor cable. The motor’s direction to be set correctly before leaving the factory. This operation is only needed when the motor or cabinet is rewired.
7．Check direction of the vacuum pump and Roots pump by checking the oil outlet pump’s direction. The motor’s direction to be set correctly before leaving the factory. This operation is only needed when the motor or cabinet is rewired.
8．Turn on the vacuum pump. After running for 5 minutes, check whether the oil level of vacuum pump and roots pump is within the allowable range.
9．Select the operating mode "Manual or Auto". Set to "Manual" at the factory.
10． Enter the "Set" menu to set operation parameters. At the factory, heating temperature is set to 60 ° C.
Hot Tags: 6000l/h mobile high vacuum transformer oil filtration machine, China, suppliers, manufacturers, price, for sale, portable transformer oil filtration machine, transformer oil filtration plant, Vacuum Insulating Oil Filtration System, best price transformer oil filtration machine, oil treatment regeneration machine, portable transformer oil centrifugal machine, transformer oil cleaning plant, 6000lh high vacuum transformer oil filtration machine, transformer oil filtration machine enclosed 3000lph, oilfiltrationmachine, power transformer oil filtration machine 6000lph, dielectric oil filtration apparatus, Oil Recycling Machine, Insulation Resistance Tester, lubricating oil purifier machine, insulating oil purifier, Digital Insulation Resistance Tester Price, single stage vacuum transformer oil purifier
Send Inquiry
