+86-312-6775656

Significance of Measuring Trace Moisture in Oil Products

Nov 30, 2022

The water content in crude oil will increase the transportation volume, and more importantly, it will bring difficulties in crude oil processing, which will increase the energy consumption of atmospheric and vacuum distillation units. Since the relative molecular energy of water is much smaller than that of oil, the volume increases sharply after gasification, which increases the system pressure drop and power consumption. Therefore, the high content of oil will cause the unit operation to fluctuate and cause tower flushing. Moreover, the inorganic salts (Call2, MgCl2) brought in by water will also aggravate the corrosion of the device. Water in light fuel oil will increase the freezing point and crystallization point, which will lead to poor low temperature hydrodynamic performance of the oil, causing the oil to analyze ice particles at low temperature and block the filter and oil path, especially the water in aviation kerosene and diesel, which will cause oil supply interruption and lead to serious accidents. If there is water in the lubricating oil, the lubricating film will be damaged, which will prevent the normal lubrication and increase the wear of the parts. Inorganic salts brought in by water will also increase the corrosivity of lubricating oil and aggravate the corrosion of parts. When water containing lubricating oil is used to work in a high temperature environment, the lubricating film will be damaged due to the evaporation of water. If the water content in the reforming feed oil exceeds the standard, the catalyst will be poisoned. Because too much water in the oil occupies the acid center of the catalyst, the balance of the metal center of the acid center is destroyed, the catalyst activity is reduced or even deactivated, and the service life of the catalyst is affected. Therefore, water content is an indispensable quality indicator in various oil standards.


The determination of water content in oil products can provide accurate measurement of the quantity of oil products, that is, the actual quantity of oil in the entire container can be known by subtracting the water content after measuring the ruler. If the water content in the oil is measured, the dehydration method can be determined according to its content to prevent the following hazards: for example, when the water in the oil product evaporates, it needs to absorb heat, which will reduce the calorific value; The water in light oil will worsen the combustion process, and can bring dissolved salt into the cylinder to form carbon deposits, increasing the wear of the cylinder; At low temperatures, the water in the fuel will freeze, blocking the fuel duct and filter, and hindering the fuel supply of the generator fuel system; The presence of water in petroleum products will accelerate the oxidation of raw rubber; When there is water in the lubricating oil, it will not only cause corrosion of engine parts, but also turn into water vapor when water contacts with metal parts higher than 100 ℃, damaging the lubricating oil film. Light oil has low density, low viscosity and easy separation of oil and water. On the contrary, heavy oil is not easy to separate. The water content of crude oil entering the atmospheric and vacuum distillation unit is required to be no more than 0.2%~0.5%; The specification and standard of product oil requires that gasoline and kerosene shall be free of water, and the water content of light diesel shall not be greater than the trace; The moisture content of heavy diesel oil shall not be greater than 0.5%~1.5%; All kinds of lubricating oil and fuel oil have corresponding control indicators.

Send Inquiry